Tag Archives: BGP

Cisco to Juniper BGP command conversions

Posted on March 15, 2020 by danmassey99

This is a short post to get a few BGP commands down that have become second nature on Cisco equipment but seem harder to tease out on JunOS! 1. Show a summary of the current BGP state: Cisco: show ip … Continue reading →

Posted in Juniper | Tagged , , | Comments Off on Cisco to Juniper BGP command conversions

Cisco ASA BGP configuration

Posted on November 20, 2019 by danmassey99

In this post we will examine the use of BGP in the Cisco ASA to allow failover between 2 ethernet style connections from the same ISP. There is no reason to doubt that this would not work with a PPPoE … Continue reading →

Posted in Cisco | Tagged , , | Comments Off on Cisco ASA BGP configuration

Let’s talk about AF-Groups, Session-Groups and Neighbor-Groups

Posted on October 26, 2019 by danmassey99

After the spin round the block with IOS-XE ‘scaled configuration’ features, this is the accompanying IOS-XR version. First thing first we need to create the ‘long-hand’ version that we used on XE but for XR. The config on XR changes … Continue reading →

Posted in Cisco | Tagged , , , , | Comments Off on Let’s talk about AF-Groups, Session-Groups and Neighbor-Groups

IPv6 Tunnel using BGP on a Cisco 877

Posted on March 1, 2013 by danmassey99

The last post was about basic IPv6 tunnelling using GRE and a static route from the ISP router to the Cisco 887 at the remote site. That all worked , but lacked ‘interest’. I had considered putting in a Cisco … Continue reading →

Posted in Cisco, IPv6 | Tagged , , | Leave a comment